COST ESTIMATE

The cost of this item would vary according to the size of it. The completed project would have three components. The idea or concept came from completing two of the three components. These could be used to repair a battery and the third would put it on automatic. After finding the problem with it then go to the next step. If it charges up but fails to work properly then go to that section. If it doesn't charge up then go to that section. Usually a battery fails to charge up because of the memory effect.Finding a source of energy to put into it would probably change it somewhat but would flush the memory to some extent. This would be dis-advantagous because it would cause it to charge up but fail to work properly. So if the problem is like this then you've got a problem just like a problem you've created just like a problem you might not have created. This could be repaired by bombarding it with something that would put the gell back in gell-cell similiar to the memory effect that causes some not to charge up. This takes a lot of trial and error so putting it on automatic would be nice.The table below is an example of the do's and dont's or pros cons. If the pros are one of the two type of work or sections of the repair job and the cons are the other then what I'm trying to say is that the pros and cons are also the types of problems. If for example the problem is that it will not charge up then this might be because it was used in a high absorbant type of use. This is like a bass tone. An high pitch tone is like an energy signature. A magnet is a good example of a high absorbant.

Looking for a practical way of putting these components together is like looking for a schematic of a battery charger that ruins the battery by making it charge up without the absorbant quality, and then looking for a schematic that ruins the battery by using it for a high absorbent like an electromagnet. I'm an artist and I make these components to use for repairing batteries. I don't know of any where else to get that type of electronic equipment at the present time. I make capacitors and resistors that I use for this. I'm currently evaluating putting these together in a way that resembles a battery. An inverter, amplifier and solar switch are also in the works.

PROS	CONS
CHARGES UP	SMALLER AMP/HRS
DOESN'T CHARGE UP	DOESN'T CHARGE UP
THE ABOVE TWO IS NOT WHAT WE WANT	THE ABOVE TWO IN THE RIGHT RATIO